Dura Seal™ X-TERRA is a two-component, urethane/acrylic resin blend formulated specifically for the demands of commercial and high traffic residential hardwood floors. Its unique technology provides a long- wearing, commercial grade finish that is the ultimate in durability.

• Product Use: New Floors, Natural
• Sand and prepare floor according to NOFMA or NWFA recommended methods.
• Finish sanding with a 120 or 150 grit screen. Do not use steel wool.
• Vacuum thoroughly and tack floor with a slightly water-dampened cloth to remove all dust.
• Apply 1 coat of Dura Seal™ Super Base Sealer
• Apply 2 coats of Dura Seal™ X-Terra.
• For high traffic commercial applications, a third coat is recommended.

• Product Use: New Floors, Stained
• Sand and prepare floor according to NOFMA or NWFA recommended methods.
• Finish sanding with a 100 grit screen. Do not use steel wool.
• Apply Dura Seal™ Penetrating Stain according to label directions.
• Apply 2 coats of Dura Seal™ X-Terra over thoroughly dried stain.
• For high traffic commercial applications, a third coat is recommended.

• Product Use: Previously Finished Floors
• Abrade and Recoat: Be certain floor is free from all wax or oily residue.
• Clean floor thoroughly to remove all contamination.
• Abrade floor with a 120 grit screen. Do not use steel wool.
• Vacuum thoroughly and tack floor with a slightly water-dampened cloth to remove all dust.
• Apply 2 coats of Dura Seal™ X-Terra.
• For high traffic commercial applications, a third coat is recommended.

Note: Do not apply over wax, shellac, lacquer or stains containing wax or stearates.

X-Terra will adhere to most stains and finishes after proper preparation. Always prepare a sample or test area to determine compatibility.

• Product Properties
• Dry Time & Cure Time
• Recoat time: 2-3 hours between coats
• Light foot traffic is acceptable after 24 hours
• Allow one week before exposing finish to rugs, cleaners, spills or heavy traffic
• Coverage: Approximately 350-400 sq.ft. per gallon
• Clean Up: Application tools should be cleaned with warm water immediately after use.
• Maintenance: Use walk-off mats at all entrance doorways to keep dirt and grit to a minimum. Sweep or vacuum daily and damp wipe as needed with Dura Seal™ Hardwood Floor Cleaner.
• Storage: Store at room temperature. If stored at high temperature, cool to room temperature before use. Keep from freezing. If frozen, slowly warm to room temperature and mix thoroughly before using.
• Pot Life: The Finish/Hardener mix must be used within 4 hours after it is mixed. Product properties are diminished after 4 hours. The finish and hardener can only be mixed one time.

Send mail to woodfloors23@the-flooring-connection.com with questions or comments about this web site.
Copyright © 2003 The Flooring Connection
Last modified: 09/15/09